When you send the information, it transmits data across It sets its CTS signal to a marked state to indicate to If the DTE is not able to receiveĭata-because of buffer conditions, for example-it sets
It sets its RTS signal to a marked state all 1s to indicate When the DTE device is ready to receive data: This establishes the link and traffic can pass. The DCE transmits a DSR signal to the DTE, which responds 8-Port Synchronous Serial GPIM on SRX devices.
This support on serial interfaces is the same as the existing LFIĪnd MLPPP support on T1 and E1 interfaces. See Configuring Logical Interface Properties. There are no serial interface-specific logical properties.įor information about general logical properties that you can configure, Standard (known as EIA-449) is compatible with RS-422 signal levels. RS-232 -A Recommended Standard (RS) known as EIA-232. Standards to configure serial interfaces typeĮIA-530-An Electronics Industries Alliance (EIA) For information about platforms support, see hardware compatibility tool